CATALOGUE
ELECTRICITY
EMBEDDED COMPUTING
INSTALLERS
CONSULTING BLOG
New products
CATALOGUE
ELECTRICITY
EMBEDDED COMPUTING
INSTALLERS
CONSULTING BLOG
This range of panels is particularly suitable for metal boats (yachts or steel) for which bipolar models are preferred. They use bipolar switches to prevent any risk of current leakage from the negative or positive when the circuit is not powered. In the event of a failure of the electrical installation, a circuit-breaker placed on the positive line disarms. Once the cause of the failure has been found (failure of a connection, problem on a device), the circuit-breaker can be reset and the installation is operational again.
Like our unipolar switchboards, the bipolar switches incorporate an LED to indicate the operating status of the circuit
Each output is protected by a thermal circuit breaker calibrated from 3 to 15 Amperes (to be determined when ordering)
Like the unipolar range, these panels are compatible with 12/24 volts and are available with wiring kits to ensure a successful and easy installation and maintenance on board. We also offer customizable models (visual and dimensions) that will perfectly fit your boat.
A label plate is provided with the table.
| Version | 16 bipolar circuits |
|---|---|
| Function | Control and circuit protection. |
| Voltage | 12 V or 24 V |
| Type of circuit-breaker | Thermal (from 3 to 15 A). |
| Switch switch | Bipolar with LED for circuit operation monitoring. |
| Operating temperature range | From -20°C to 50°C |
| Connection technology | 6.3mm female clip terminals |
| Dimensions (H x W) | 250mm*280mm |
| Pre-wiring | The panel is pre-wired
Optionally mounted terminal block |
The entire range has been designed to be modular, so the switchboards can be combined with each other to guarantee the scalability of the installation. In addition, care has been taken with the quality of the cables and terminals used (reinforced terminals) to ensure maximum reliability of the system.
In addition to the switchboards, a set of terminal blocks fixed on DIN rail, in order to ensure an optimal distribution from each of the circuits, is proposed. These terminal blocks are available in kit form or can be pre-wired in our Saint Malo workshop. In the case of the pre-wired version, the length of the harness between the panel and the terminal blocks must be specified.
These panels are assembled in our workshop in Saint Malo, which allows us to adapt your choice of circuit breaker rating to your needs. You can use the following link to send us your CHOICE OF BREAKER SIZE.
Pre-assembled wiring kits ensure a professional, successful and easy to maintain installation on board.
The kit is a set of terminal blocks mounted on a DIN rail connected to a wiring harness for connection to the boat's electrical panel. All you need to do is connect the boat's consumers to get a clear installation. Visually, the distribution from the electrical panel becomes clear and understandable, making it easier to maintain and service your boat.
This kit comes with all the components pre-assembled allowing you to carry out the installation as a professional would.
| Function | Wiring kit for connection of 16 circuit breakers |
|---|---|
| Permissible cable cross-section | from 1 to 4mm². |
| Connection method | For vis |
| Max current per terminal block | 20A |
| Compliance | TBA |
| Dimensions | 2 x 480*48*47mm |
| Contents of the Kit |
|
Sur notre blog conseil, découvrez LE TABLEAU ÉLECTRIQUE FABRIQUÉ SUR MESURE pour cette belle vedette de 1933, ainsi que d'autres tableaux électriques.
