- 1 Sunpower 205 W rigid panel
- Fixing kit for tube.
- Specify tube diameter (possible from Ø22 to Ø55mm)
The Sunsaver MPPT controller is designed to regulate the load of solar panels with a power of up to 200 W at 12 V or 400 W at 24 V. In addition to being particularly robust (electronic board wrapped in an epoxy layer, anodized aluminum case), it integrates the new MPPT (Maximum Power Point Tracking) function. This system allows you to be placed at any time at the point of best performance of the solar panel to maximize the amount of energy produced (the daily gain can reach 30% compared to a conventional regulator). It protects your batteries from overloads and recharges them in an optimal way thanks to a three-phase charge cycle integrating temperature compensation.
|Automatic detection||12 V or 24 V.|
|Power 12 V/24 V||200 W / 400 W.|
|Maximum panel voltage||75 V.|
|LCD control panel||Yes as an option|
|Battery type setting||4 charge cycles available (Gel, Closed Lead, Open Lead, AGM).|
|Charge cycle||Three-phase charge cycle with temperature compensation for optimal battery charging. Equalization cycle (depending on battery type selection).|
|Temperature compensation||- 0,03 V/degree.|
|Electrical protections||Solar panel overproduction/temperature/short circuit.|
|Dimensions||169 x 64 x 73 mm.|
|Section in mm² of the terminal blocks||5 mm².|
|Maximum consumer current||20 A.|
Les régulateurs MPPT optimisent le rendement des panneaux solaires - plus d'infos sur cette technologie sur notre blog conseil.