- Arm of 19 cm
- VESA 75-100 compatible
This MPPT 60A solar controller optimizes the efficiency of solar panels. It is suitable for 12V, 24V, 36V and 48V installations. (up to 800W of 12V and 1600W of 24V panels), it also has a three-phase charging cycle with temperature compensation.
|Function||Optimization of the efficiency of the solar panels (gain of 20 to 30%) and complete and optimal charging of the battery.|
|Maximum power of the panels (12V/24V/36V/36V/48V)||800W/1600W/2400W/2400W/3200W|
|Maximum panel tension||150V|
|LCD control panel||Easy setting of the regulator and access to voltage and load information (current produced by the panels, voltages, etc.)|
|Setting the battery type||4 charging cycles available (including one for gel and lithium batteries) and one charging cycle fully configurable by the user.|
|Charging cycle||Three-phase charging cycle with temperature compensation for optimal battery charging. Equalization cycle (depending on the selection of the battery type)|
|Self-consumption||0.7W to 1.2W|
|Electrical protection||Battery and solar panel polarity reversal / Solar panel overproduction / Temperature / Short circuit of panel input and consumer output|
|Section mm² terminal blocks||16mm² (16mm²)|
|Maximum current consumers||20A|
The efficiency of MPPT technology on this range of controllers reaches 98%, and the additional technology of Multi Peak Tracking Technology allows to increase the production of the solar installation in the case of a shadow partially projected on a panel.
In addition to pre-programmed charging cycles, suitable for gel, AGM and open batteries, the regulator allows the implementation of a charging cycle with customized voltages. The controller allows solar production data to be stored for up to one year.
This range extends from 10 to 60 Amps. You will find the entire range in the product sheet available under this link.
Les régulateurs MPPT optimisent le rendement des panneaux solaires - plus d'infos sur cette technologie sur notre blog conseil.